- ページ 10

ネットワーク・ハードウェア Cisco ASA 5506W-XのPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。Cisco ASA 5506W-X 46 ページ。 Threat defense reimage guide
Cisco ASA 5506W-X にも：クイック・スタート・マニュアル (10 ページ), 設定マニュアル (13 ページ), クイック・スタート・マニュアル (14 ページ), 簡単セットアップマニュアル (11 ページ), ソフトウェアマニュアル (37 ページ), マウント＆コネクト (12 ページ), シャーシをマウントする (10 ページ)

Rear Panel

Reset button

A small recessed button that if pressed for longer

than three seconds resets the ASA to its default

"as-shipped" state following the next reboot.

Configuration variables are reset to factory

default. However, the flash is not erased and no

files are removed.

Note

The following figure shows the rear panel of the 5506H-X.

Figure 6: ASA 5506H-X Rear Panel

Power cord socket.

The chassis power-supply socket. See

Supply Modules, on page 11

information about the chassis power supply.

Note

Cisco ASA 5506-X, ASA 5506W-X, and ASA 5506H-X Hardware Installation Guide

You can use the service

sw-reset-button command to disable

the reset button. The default is enabled.

Pressing the reset button on the ASA

5506W-X does not affect the AP

configuration, but it causes any

unsaved AP configuration to be lost,

because the system has rebooted. After

the system reboots, if you want a

default AP configuration, use the

hw-module module wlan recover

configuration command to recover

the AP configuration.

for more

The ASA is powered on when you

plug in the AC power supply.

Lock slot

The slot accepts a standard Kensington T-bar

locking mechanism for securing the ASA.

Status LEDs

Power

The locations and meanings of the status LEDs

are described in

Overview

LEDs, on page

Online Only