- ページ 8

ネットワーク・ハードウェア Cisco GS7000のPDF 取付説明書をオンラインで閲覧またはダウンロードできます。Cisco GS7000 13 ページ。 Gainmaker node forward local injection module
Cisco GS7000 にも：メンテナンス・マニュアル (15 ページ), トラブルシューティング (4 ページ), トラブルシューティングマニュアル (12 ページ)

FLI Module Installation

Closing the Housing

Close the housing as follows.

Ensure any worn gaskets are replaced, and the gaskets are clean and in the

correct position.

Carefully close the lid.

For strand-mounted housings, pull the lid away from the base and remove the

slack from the hinge before rotating the lid up toward the base.

Ensure no cables are pinched between lid and base.

Secure lid to base with bolts. Tighten from 5 to 12 ft-lbs (6.8 to 16.3 Nm) in the

sequence shown in the following illustration. Repeat the sequence twice, ending

with the final torque specification.

Depending on the module population of your particular node, it may be necessary to

relocate or remove and replace an optical receiver or transmitter to facilitate the

installation of the FLI Module.

If necessary, complete the following steps to remove and replace an optical receiver

or optical transmitter.

Open the node housing.

Carefully tag and remove any optical fibers from the receiver or transmitter

module.

CAUTION:

Use caution when closing housing. Improper closing may result in the Model

GS7000 Node not being sealed from the environment.

4019330 Rev C