- ページ 4
ネットワーク・ハードウェア Cisco PIX 525のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Cisco PIX 525 30 ページ。 Security appliance
Cisco PIX 525 にも： データシート (13 ページ)
ページを印刷する
Installing the PIX 525
Connect the cable so that you have either a DB-9 or DB-25 connector on one end as required by the serial
Step 2
port for your computer, and the other end is the RJ-45 connector as shown in
Note
Connect the RJ-45 serial cable connector to the PIX 525 console connector and connect the other end to
Step 3
the serial port connector on your computer.
Figure 6-5
Connect the outside network cable to the remaining Ethernet port. Refer to the
Step 4
Licenses" section on page 6-5
Note
Step 5
If you need to install an optional circuit board, refer to the
section on page
on page 6-12
Note
Cisco PIX Security Appliance Hardware Installation Guide
6-4
Use the Console port to connect a computer to enter configuration commands. Locate the serial
cable from the accessory kit. The serial cable assembly consists of a null modem cable with
RJ-45 connectors, and one DB-9 connector and a DB-25 connector.
PIX 525 Rear Panel
100Mb ps ACT
LINK
100Mb ps ACT
10/1 00 ETH ERN ET 1
10/1 00 ETH ERN ET 0
RJ-45 to
DB-9 or DB-25
serial cable
(null-modem)
for information on how to configure the ports.
The inside or outside network connections can be made to any available interface port on the
PIX 525. If you are only using the ETHERNET 0 and ETHERNET 1 ports, connect the inside
network cable to the interface connector marked ETHERNET 0 or ETHERNET 1.
6-15. If you need to install memory, refer to the
for more information.
It is not necessary to remove the chassis cover of the PIX 525 to access the circuit boards or
memory.
F
A
I
L
O
V
E
R
LINK
PIX-52 5
USB
CON SOL E
Console
port (RJ-45)
"Installing a Circuit Board in the PIX 525"
Chapter 6
Figure
6-5.
PC terminal adapter DB-9
"PIX 525 Feature
"Installing a Memory Upgrade" section
PIX 525
78-15170-02