- ページ 3
サーバー Cisco SCE8000 GBEのPDF インストールをオンラインで閲覧またはダウンロードできます。Cisco SCE8000 GBE 21 ページ。 10gbe platform
Cisco SCE8000 GBE にも： クイック・スタート・マニュアル (25 ページ), 設定マニュアル (18 ページ), 取り外しと交換の手順 (36 ページ)
ページを印刷する
Chapter 4 Installing the Cisco SCE8000 Chassis
Site Requirements
This section provides site power requirements for the Cisco SCE8000 chassis. Verify the site power
before installation.
•
•
•
Preventing Electrostatic Discharge Damage
Electrostatic discharge (ESD) damage, which can occur when electronic cards or components are
improperly handled, results in complete or intermittent failures. Port adapters and blades consist of
printed circuit boards that are fixed in metal carriers. Electromagnetic interference (EMI) shielding and
connectors are integral components of the carrier. Although the metal carrier helps to protect the board
from ESD, use a preventive antistatic strap during handling.
Following are guidelines for preventing ESD damage:
•
•
•
•
•
•
•
•
For safety, periodically check the resistance value of the antistatic strap. The measurement should be
Caution
between 1 and 10 megohm (Mohm).
Environmental Requirements
Ensure adequate spacing between racks using the information in the following table. Keep all of the
vents clear of obstructions, including dust and foreign conductive material, and away from the exhaust
ports of other equipment.
Cisco SCE 8000 environmental requirements.
OL-21054-04
Preventing Electrostatic Discharge Damage, page 4-3
Environmental Requirements, page 4-3
Power Requirements, page 4-4
Always use an ESD wrist or ankle strap and ensure that it makes good skin contact.
Connect the equipment end of the strap to an unfinished chassis surface.
When installing a component, use any available ejector levers or captive installation screws to
properly seat the bus connectors in the backplane or midplane. These devices prevent accidental
removal, provide proper grounding for the system, and help to ensure that bus connectors are
properly seated.
When removing a component, use any available ejector levers or captive installation screws to
release the bus connectors from the backplane or midplane.
Handle carriers by available handles or edges only; avoid touching the printed circuit boards or
connectors.
Place a removed component board-side-up on an antistatic surface or in a static shielding container.
If you plan to return the component to the factory, immediately place it in a static shielding
container.
Avoid contact between the printed circuit boards and clothing. The wrist strap only protects
components from ESD voltages on the body; ESD voltages on clothing can still cause damage.
Never attempt to remove the printed circuit board from the metal carrier.
Table 4-1
lists the chassis airflow requirements, and
Cisco SCE8000 10GBE Installation and Configuration Guide
Site Requirements
Table 4-2
lists the
4-3