- ページ 6

サーバー Cisco UCS B200 M4のPDF アップグレードマニュアルをオンラインで閲覧またはダウンロードできます。Cisco UCS B200 M4 9 ページ。 For e5-2600 v4 series cpus
Cisco UCS B200 M4 にも：インストールとサービスノート (30 ページ), インストールとサービスノート (46 ページ), 整備マニュアル (24 ページ)

ページを印刷する

Downgrading from Intel E5-2600 v4 Series CPUs to E5-2600 v3 Series CPUs

Step 9

Make sure the Cisco UCS Manager infrastructure firmware is at Release 2.2(4) or later.

Step 10

Upgrade the capability catalog to Release 2.2(7) or later.

Step 11

Use Cisco UCS Manager to upgrade and activate the server CIMC to Release 2.2(7) or later. Use the procedures in the

appropriate upgrade guide (depending on your current software version):

Step 12

Wait for the server to be discovered by Cisco UCS Manager.

Step 13

Wait for Cisco UCS Manager to automatically activate the board controller version.

Step 14

Do not continue with the next step until the board controller activation completes. Verify if the activation is complete

by using the

show version

Wait until Activate-Status returns Ready. This process takes a few minutes before it successfully completes and returns

Ready.

# show version

BoardController:

Runnning-Vers: x.0

Package-Vers:

Activate-Status: Ready

Downgrading from Intel E5-2600 v4 Series CPUs to E5-2600 v3 Series CPUs

Before You Begin

This downgrade procedure requires server downtime.

Note

This scenario assumes the following conditions:

• The Cisco UCS Manager software is at the required minimum version or later.

• The server is using BIOS/CIMC that is at the required minimum version or later.

• The server is using Intel E5-2600 v4 Series CPUs.

If you upgraded the server to Intel E5-2600 v4 Series CPUs and the server is running UCS firmware that

Caution

added support for Intel E5-2600 v4 Series CPUs, and if you installed the Trusted Platform Module (TPM)

2.0, do not downgrade the firmware and BIOS to a version earlier than Release 2.2(7) or Release 3.1(1).

If you do so, then you are vulnerable to a potential security exposure. For additional information, see

"Enabling the Trusted Platform Module" in the

Note.

Step 1

Disassociate the server in Cisco UCS Manager.

Step 2

Power off the server.

Step 3

Replace the Intel E5-2600 v4 Series CPUs with the E5-2600 v3 Series CPUs.

Cisco UCS B200 M4 Server Upgrade Guide for E5-2600 v4 Series CPUs

command.

Cisco UCS Manager Upgrade

Cisco UCS B200 M4 Blade Server Installation and Service

Introduction

Guides.