- ページ 5

デスクトップ Epson Equity IIeのPDF 製品情報マニュアルをオンラインで閲覧またはダウンロードできます。Epson Equity IIe 8 ページ。 Product support bulletin(s)
Epson Equity IIe にも：製品サポート速報 (19 ページ), 製品サポート速報 (19 ページ), 製品サポート速報 (45 ページ)

ページを印刷する

Installation / Support Tips

Power

The Equity He has a power supply that is switchable between

115 V, for USA and Canadian use, and 23fIV, for use in other

countries. The voftage switch is located at the rear of the CPU

between the AC inlet and the AC outlet. (see figure below)

The voltage is not changed between the

AC inlet and the AC outlet. lf the CPU is switched for

certified for use at 230 V should be plugged into the

outlet.

Installing Floppy Disk Drives

When installing a floppy disk drive as drive B,

remember to set the drive select jumper to the

second position and attach the pass-through

connector on the floppy drive controller cable to the

drive, not the end connector.

Equity Series Computers

that the drive type haa been correctly seNcted In

SETUP. Aleo check that any apeolal drivers that

may be v have been tnsta5ed correotly.

Installing Hard Disk Drives

controller be used in the Equity IN, if you are

installing a drive that cannot make use of the

internal HI board. AJso remember to disable the Hi

board when Installing such a drfve.

Format option in diagnostics.

Setup

When installing an optional expanded memory

board, do not list the memory under the memory

expansion option in SETUP. That optfon is for

EXTENDED memory ONLY.

When installing a hard disk drfve, be sure to cons&

the drive type tables (on page EOlfe-4) for the drive

type which ffts the drive you are installing.

Adding Memory Modules

following: 1 MB, 2MB, 3MB or 5MB.

Memory banks must be filled with one size SIMM.

You cannot mix SIMM types in one bank.

Software Problems

When installing a copy-protected software package

on the Equity lie, first try the installation at 12 MHz.

8 MHz for the installation. lf you are still unable to

load the program at 12 MHz, try loading at 8MHz

and then switching to 12 MHz.

When using a software pa&age that uses a keydlsk

as it copy-protection method, try loading it at 12

MHz. lf this does not work, enable the Auto Speed

option in SETUP.

EQUITY Ile

EQlle-5