Epson Equity IIe Ürün Bilgi Kılavuzu - Sayfa 5

Masaüstü Epson Equity IIe için çevrimiçi göz atın veya pdf Ürün Bilgi Kılavuzu indirin. Epson Equity IIe 8 sayfaları. Product support bulletin(s)
Ayrıca Epson Equity IIe için: Ürün Destek Bülteni (19 sayfalar), Ürün Destek Bülteni (19 sayfalar), Ürün Destek Bülteni (45 sayfalar)

Sayfayı Yazdır
Epson Equity IIe Ürün Bilgi Kılavuzu
Installation / Support Tips
Power
The Equity He has a power supply that is switchable between
115 V, for USA and Canadian use, and 23fIV, for use in other
countries. The voftage switch is located at the rear of the CPU
between the AC inlet and the AC outlet. (see figure below)
The voltage is not changed between the
AC inlet and the AC outlet. lf the CPU is switched for
certified for use at 230 V should be plugged into the
outlet.
Installing Floppy Disk Drives
When installing a floppy disk drive as drive B,
remember to set the drive select jumper to the
second position and attach the pass-through
connector on the floppy drive controller cable to the
drive, not the end connector.
Equity Series Computers
that the drive type haa been correctly seNcted In
SETUP. Aleo check that any apeolal drivers that
may be v have been tnsta5ed correotly.

Installing Hard Disk Drives

controller be used in the Equity IN, if you are
installing a drive that cannot make use of the
internal HI board. AJso remember to disable the Hi
board when Installing such a drfve.
Format option in diagnostics.
Setup
When installing an optional expanded memory
board, do not list the memory under the memory
expansion option in SETUP. That optfon is for
EXTENDED memory ONLY.
When installing a hard disk drfve, be sure to cons&
the drive type tables (on page EOlfe-4) for the drive
type which ffts the drive you are installing.

Adding Memory Modules

following: 1 MB, 2MB, 3MB or 5MB.
Memory banks must be filled with one size SIMM.
You cannot mix SIMM types in one bank.

Software Problems

When installing a copy-protected software package
on the Equity lie, first try the installation at 12 MHz.
8 MHz for the installation. lf you are still unable to
load the program at 12 MHz, try loading at 8MHz
and then switching to 12 MHz.
When using a software pa&age that uses a keydlsk
as it copy-protection method, try loading it at 12
MHz. lf this does not work, enable the Auto Speed
option in SETUP.
EQUITY Ile
EQlle-5