Epson Equity IIe 제품 정보 매뉴얼 - 페이지 5
{카테고리_이름} Epson Equity IIe에 대한 제품 정보 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Epson Equity IIe 8 페이지. Product support bulletin(s)
Epson Equity IIe에 대해서도 마찬가지입니다: 제품 지원 게시판 (19 페이지), 제품 지원 게시판 (19 페이지), 제품 지원 게시판 (45 페이지)
페이지 인쇄
Installation / Support Tips
Power
The Equity He has a power supply that is switchable between
115 V, for USA and Canadian use, and 23fIV, for use in other
countries. The voftage switch is located at the rear of the CPU
between the AC inlet and the AC outlet. (see figure below)
The voltage is not changed between the
AC inlet and the AC outlet. lf the CPU is switched for
certified for use at 230 V should be plugged into the
outlet.
Installing Floppy Disk Drives
When installing a floppy disk drive as drive B,
remember to set the drive select jumper to the
second position and attach the pass-through
connector on the floppy drive controller cable to the
drive, not the end connector.
Equity Series Computers
that the drive type haa been correctly seNcted In
SETUP. Aleo check that any apeolal drivers that
may be v have been tnsta5ed correotly.
Installing Hard Disk Drives
controller be used in the Equity IN, if you are
installing a drive that cannot make use of the
internal HI board. AJso remember to disable the Hi
board when Installing such a drfve.
Format option in diagnostics.
Setup
When installing an optional expanded memory
board, do not list the memory under the memory
expansion option in SETUP. That optfon is for
EXTENDED memory ONLY.
When installing a hard disk drfve, be sure to cons&
the drive type tables (on page EOlfe-4) for the drive
type which ffts the drive you are installing.
Adding Memory Modules
following: 1 MB, 2MB, 3MB or 5MB.
Memory banks must be filled with one size SIMM.
You cannot mix SIMM types in one bank.
Software Problems
When installing a copy-protected software package
on the Equity lie, first try the installation at 12 MHz.
8 MHz for the installation. lf you are still unable to
load the program at 12 MHz, try loading at 8MHz
and then switching to 12 MHz.
When using a software pa&age that uses a keydlsk
as it copy-protection method, try loading it at 12
MHz. lf this does not work, enable the Auto Speed
option in SETUP.
EQUITY Ile
EQlle-5