- ページ 19

ソフトウェア Epson PowerLite 8300i with EasyMP.net moduleのPDF クイックマニュアルをオンラインで閲覧またはダウンロードできます。Epson PowerLite 8300i with EasyMP.net module 20 ページ。 Release of check tool for network projectors v1.00 for windows
Epson PowerLite 8300i with EasyMP.net module にも：ユーザーマニュアル (42 ページ), 操作マニュアル (36 ページ), 操作マニュアル (47 ページ), クイックセットアップ (2 ページ), 製品サポート速報 (27 ページ), パーツリスト (1 ページ), 補足マニュアル (2 ページ), パンフレット＆スペック (2 ページ), ユーザーマニュアル (1 ページ), 製品サポート速報 (25 ページ), 製品サポート速報 (22 ページ), 製品サポート速報 (28 ページ), 製品サポート速報 (41 ページ), 製品サポート速報 (34 ページ), 製品サポート速報 (28 ページ), 製品サポート速報 (15 ページ), 製品サポート速報 (22 ページ), クイックセットアップ (2 ページ)

ページを印刷する

Epson PowerLite 8300i with
EasyMP.net module クイックマニュアル

EPSON PowerLite 8300i Projector

Replacing the Lamp

The projection lamp typically lasts for about 3000 hours in

low-brightness mode, or 2000 hours in high-brightness mode.

Note: The brightness setting can be changed by selecting

in the projector's Advanced2 menu.

Brightness Control

It is time to replace the lamp when:

The projected image gets darker or starts to deteriorate.

The message

LAMP REPLACE

the lamp comes on and the lamp warning light

flashing orange. To maintain projector brightness and

image quality, replace the lamp as soon as possible.

The lamp warning light

burnt out).

Contact your dealer or call EPSON at (800) 873-7766 in the

United States for a replacement lamp. Request part number

. In Canada, please call (800) 463-7766 for

V13H010L23

dealer referral

Follow these steps to replace the lamp:

1. Turn off the projector.

2. When the power light stops flashing, unplug the power

cord and let the projector cool.

Warning: Let the projector cool for at least half an hour, if it

has been on. The lamp is extremely hot immediately after use.

3. If the projector is mounted on the ceiling, remove the rear

cover.

EPSON PowerLite 8300i Projector

appears on the screen when

is flashing red (the lamp is

Release tab to

remove rear cover

4. Loosen the lamp cover screws (you don't need to take them

out all the way). Then remove the cover.

5. Loosen the three screws holding the lamp in place (you

can't remove them).

6. Grasp the wire handle as shown and pull the lamp straight

out.

7. Gently insert the new lamp.

8. Once the lamp is fully inserted, tighten its screws and

replace the cover. (The projector won't come on if the lamp

cover is loose.)

9. Reset the lamp timer (select

projector's

About

5/03

Reset Lamp Timer

menu).

in the