- ページ 6

換気フード Whirlpool UXI1200DYSのPDF 取付説明書をオンラインで閲覧またはダウンロードできます。Whirlpool UXI1200DYS 20 ページ。 600 cfm and 1200 cfm in-line blowers for range hoods
Whirlpool UXI1200DYS にも：製品寸法 (1 ページ)

ページを印刷する

INSTALLATION INSTRUCTIONS

P i pc:;ssst

Before making cutouts, make sure there is proper clearance

within the ceiling or wall for the exhaust vent.

When cutting or drilling into the ceiling or wall, do not

damage electrical wiring or other hidden utilities.

Check that all installation parts have been removed from the

shipping carton.

1. Disconnect

power.

2. Determine which venting method to use: roof or wall exhaust.

Excessive

Weight Hazard

Use two or more people to move and install

range hood.

Failure to do so can result in back or other injury.

Pull the spring clip to release the blower motor assembly.

Remove the blower motor assembly from the housing and

place it on a covered surface.

3. Using 2 or more people, move the in-line blower motor

system to the mounting location.

Prepare for Mounting

the In-line Blower System

The in-line blower system must be fastened to a secure structure

of the roof, ceiling, wall, floor, or new or existing frame

construction.

The 4 holes on either the inlet (bottom) side or the

outlet (top) side of the blower must be used to mount the in-line

blower system to the structure.

NOTE: The mounting hole locations must span the studs.

Additional stud framing may be required. Plywood may be used

to span open areas between ceiling joists or roof rafters to aid

installation. This structure must be strong enough to support the

weight of the in-line blower system (50 Ib [22.6 kg] mini.

Prepare the In-line Blower System

1. Remove the 10 screws from the front cover of the in-line

blower motor housing and set them aside.

2. Remove the front cover of the in-line blower motor housing

and set it aside.

NOTE: To make the in-line blower motor housing easier to

mount, the blower motor assembly can be removed. If you do not

want to remove the blower motor assembly, proceed to the

"Installation

of the In-line Blower System" section.

3. Disconnect

the motor electrical plug from the blower motor

assembly.

4. Remove the screws that secure the blower motor assembly

to the in-line blower housing and set them aside.

A. Front cover

B. Blower mounting screws

C. Spring clip

D. Motor electrical plug

Installation

of the In-line Blower System

NOTE: The blower motor housing can be mounted using 4 holes

from either the inlet side or the outlet side of the blower.

A. Mounting holes

1. Position the in-line blower motor housing in its mounting

location and mark the 4 mounting hole locations.

2. Drill 4 mounting pilot holes using a ¾d' (0.5 cm) drill bit.

3. Attach the in-line blower motor housing to the mounting

location with four 6 x 80 mm mounting screws and flat

washers.