- ページ 6

セキュリティシステム Alderon Industries VersAlarm I/O VLIO-0001のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Alderon Industries VersAlarm I/O VLIO-0001 20 ページ。 Indoor/outdoor alarm panel
Alderon Industries VersAlarm I/O VLIO-0001 にも：クイック・スタート・マニュアル (2 ページ)

ページを印刷する

Alderon Industries VersAlarm I/O VLIO-0001 ユーザーマニュアル

USER GUIDE | VersAlarm™ I/O

Installation

DISCONNECT ALL POWER SOURCES WHEN INSTALLING OR SERVICING THIS PRODUCT. FAILURE TO

TURN OFF ALL POWER SOURCES COULD RESULT IN SERIOUS INJURY OR DEATH.

Wall Mounting Enclosure

STEP 1: REMOVE BOTTOM COVER

The bottom enclosure cover is fastened by a single screw on

the bottom of the enclosure. Remove the screw and slide the

cover directly downward (1A) and then pull directly away from

the enclosure (1B).

STEP 2: INSTALLING CONDUIT / FITTINGS

Using the pre-marked center hole locations (2A), mark and drill

out on the bottom of the enclosure. The size(s) will depend on

desired conduit fitting (maximum 0.75"). Place the conduit fitting

(2B) in the drilled out hole and make sure it's secured. Then

install conduit (2C) into the fitting.

Note: Seal all conduits to prevent moisture and gases from

entering the enclosure per local codes.

CAUTION: Nonmetallic enclosure does not provide proper

grounding between conduit connections. Use grounding

bushings and jumper wires.

6 | Alderon Industries™ - Leading Edge Control Products