Alderon Industries VersAlarm I/O VLIO-0001 Podręcznik użytkownika - Strona 6

Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla System bezpieczeństwa Alderon Industries VersAlarm I/O VLIO-0001. Alderon Industries VersAlarm I/O VLIO-0001 20 stron. Indoor/outdoor alarm panel
Również dla Alderon Industries VersAlarm I/O VLIO-0001: Skrócona instrukcja obsługi (2 strony)

Drukuj stronę

Alderon Industries VersAlarm I/O VLIO-0001 Podręcznik użytkownika

USER GUIDE | VersAlarm™ I/O

Installation

DISCONNECT ALL POWER SOURCES WHEN INSTALLING OR SERVICING THIS PRODUCT. FAILURE TO

TURN OFF ALL POWER SOURCES COULD RESULT IN SERIOUS INJURY OR DEATH.

Wall Mounting Enclosure

STEP 1: REMOVE BOTTOM COVER

The bottom enclosure cover is fastened by a single screw on

the bottom of the enclosure. Remove the screw and slide the

cover directly downward (1A) and then pull directly away from

the enclosure (1B).

STEP 2: INSTALLING CONDUIT / FITTINGS

Using the pre-marked center hole locations (2A), mark and drill

out on the bottom of the enclosure. The size(s) will depend on

desired conduit fitting (maximum 0.75"). Place the conduit fitting

(2B) in the drilled out hole and make sure it's secured. Then

install conduit (2C) into the fitting.

Note: Seal all conduits to prevent moisture and gases from

entering the enclosure per local codes.

CAUTION: Nonmetallic enclosure does not provide proper

grounding between conduit connections. Use grounding

bushings and jumper wires.

6 | Alderon Industries™ - Leading Edge Control Products