Alderon Industries VersAlarm I/O VLIO-0001 User Manual - Page 6
Browse online or download pdf User Manual for Security System Alderon Industries VersAlarm I/O VLIO-0001. Alderon Industries VersAlarm I/O VLIO-0001 20 pages. Indoor/outdoor alarm panel
Also for Alderon Industries VersAlarm I/O VLIO-0001: Quick Start Manual (2 pages)
Print Page
USER GUIDE | VersAlarm™ I/O
Installation
DISCONNECT ALL POWER SOURCES WHEN INSTALLING OR SERVICING THIS PRODUCT. FAILURE TO
TURN OFF ALL POWER SOURCES COULD RESULT IN SERIOUS INJURY OR DEATH.
Wall Mounting Enclosure
STEP 1: REMOVE BOTTOM COVER
The bottom enclosure cover is fastened by a single screw on
the bottom of the enclosure. Remove the screw and slide the
cover directly downward (1A) and then pull directly away from
the enclosure (1B).
STEP 2: INSTALLING CONDUIT / FITTINGS
Using the pre-marked center hole locations (2A), mark and drill
out on the bottom of the enclosure. The size(s) will depend on
desired conduit fitting (maximum 0.75"). Place the conduit fitting
(2B) in the drilled out hole and make sure it's secured. Then
install conduit (2C) into the fitting.
Note: Seal all conduits to prevent moisture and gases from
entering the enclosure per local codes.
CAUTION: Nonmetallic enclosure does not provide proper
grounding between conduit connections. Use grounding
bushings and jumper wires.
6 | Alderon Industries™ - Leading Edge Control Products
1A
1B
2A
2B
2C