- ページ 12

ソウ Clarke CPS160のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Clarke CPS160 17 ページ。 160 mm plunge saw

GUIDE RAILS

JOINING THE RAILS TOGETHER

1. Insert the joining bar half way into

one of the rails and secure using 2

of the set screws on the joining

bar.

2. Slide the second rail over the

other half of the joining bar until

the rails are touching and secure using the remaining 2 set screws on the

joining bar.

USING THE RAILS

NOTE: Before using for the first time, perform a full length cut on a scrap piece

of wood to cut the rubber lip on the rails flush to the blade.

1. Place the plunge saw onto the

guide rails as shown.

2. Slide the plunge release button

upward and squeeze the on/off

trigger to start the saw.

3. Push the saw down until you

reach the set cutting depth.

• Remember to add the

thickness of the rails to your

measured cutting depth

(approximately 5 mm).

4. Push the saw forwards to make the cut.

5. Release the on/off trigger and allow the saw to spring up when the saw

cutting is complete.

6. If you are performing a mitre cut

using the rail, you may need to fit

the anti-tilt bracket as shown using

the clamp nut supplied.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]