- ページ 9

ソウ Clarke ZX-R Pro SeriesのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Clarke ZX-R Pro Series 13 ページ。 20v cordless multi function tool
Clarke ZX-R Pro Series にも：取扱説明書 (8 ページ), 取扱説明書 (9 ページ), 取扱説明書 (17 ページ), 取扱説明書 (17 ページ), 取扱説明書 (17 ページ)

ページを印刷する

9. To prevent accidents, turn off the tool and remove the battery after use.

Clean, then store the tool indoors out of children's reach.

PLUNGE CUTTING

Plunge cut into plywood and thin boards. Do not attempt to plunge cut into

thick, hardwood or metal panels.

1. Clearly mark the line of cut.

2. From a convenient starting point within the cutting area, place the tip of

the blade over that point with the saw parallel to the line of cut.

3. Place the edge of the pivot shoe

on the work piece with the blade

NOT touching the work material.

Squeeze the trigger to start the

tool operating. never start a

plunge cut with the blade tip

touching the work piece. this will

cause an immediate kick back,

that can damage the work piece,

and blade or cause injury.

4. Wait for the saw to reach full

speed, then slowly rotate the tool on the pivot shoe as the blade contacts

the work piece. Hold the tool firmly.

5. Continue to slowly rotate the tool until the blade has penetrated through

the work material. Press the Pivot Shoe firmly against the work material and

continue to make the cut.

CUTTING METAL

1. Install a metal cutting blade.

2. Coat the cutting surface with cutting oil to prevent the blade from

overheating.

3. Follow general cutting procedure above.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]