Clarke ZX-R Pro Series 운영 및 유지보수 지침 매뉴얼 - 페이지 9

{카테고리_이름} Clarke ZX-R Pro Series에 대한 운영 및 유지보수 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke ZX-R Pro Series 13 페이지. 20v cordless multi function tool
Clarke ZX-R Pro Series에 대해서도 마찬가지입니다: 작동, 유지보수 및 사용 설명서 (8 페이지), 운영 및 유지보수 지침 매뉴얼 (9 페이지), 운영 및 유지보수 지침 매뉴얼 (17 페이지), 운영 및 유지보수 지침 매뉴얼 (17 페이지), 운영 및 유지보수 지침 매뉴얼 (17 페이지)

9. To prevent accidents, turn off the tool and remove the battery after use.

Clean, then store the tool indoors out of children's reach.

PLUNGE CUTTING

Plunge cut into plywood and thin boards. Do not attempt to plunge cut into

thick, hardwood or metal panels.

1. Clearly mark the line of cut.

2. From a convenient starting point within the cutting area, place the tip of

the blade over that point with the saw parallel to the line of cut.

3. Place the edge of the pivot shoe

on the work piece with the blade

NOT touching the work material.

Squeeze the trigger to start the

tool operating. never start a

plunge cut with the blade tip

touching the work piece. this will

cause an immediate kick back,

that can damage the work piece,

and blade or cause injury.

4. Wait for the saw to reach full

speed, then slowly rotate the tool on the pivot shoe as the blade contacts

the work piece. Hold the tool firmly.

5. Continue to slowly rotate the tool until the blade has penetrated through

the work material. Press the Pivot Shoe firmly against the work material and

continue to make the cut.

1. Install a metal cutting blade.

2. Coat the cutting surface with cutting oil to prevent the blade from

overheating.

3. Follow general cutting procedure above.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]