- ページ 13

3Dプリンター 3D Systems CUBEのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。3D Systems CUBE 20 ページ。 Replacing the print tip
3D Systems CUBE にも：ドキュメンテーション (8 ページ), レッスン (15 ページ)

ページを印刷する

NOTE: If Auto Gap is not successful, it is recommended that you perform Auto

Level and Auto Gap again. Select AUTO LEVEL to continue.

NOTE: If Auto Gap is not successful the second time, select PLATE

MAINTENANCE. For more information, refer to the section titled

Maintenance. Once the Plate Maintenance procedure has been performed,

perform Auto Level and Auto Gap.

NOTE: If Auto Gap is still not successful, select MANUAL GAP ADJUSTMENT.

Refer to the section titled

Manual Gap Adjustment procedure has been performed, note the ﬁnal reading

for future reference.

Manual Level

If the print pad is out of range, you will need to perform a manual adjustment.

Remove the print pad and select the

NOTE: To remove it, lift up the front of the print pad and pull it out of the

printer. The print pad is magnetically attached to the adjustment knobs.

Manual Level

for more information. Once the

checkmark

to continue.

Print Pad