- ページ 6

アクセサリー 3Doodler 2.0のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。3Doodler 2.0 10 ページ。
3Doodler 2.0 にも：クイック・スタート・マニュアル (2 ページ), マニュアル (4 ページ)

ページを印刷する

1. Troubleshooting and Cleaning the Pen

minutes before stopping.

To stop the continuous flow of plastic/filament, simply click on either

the FAST (3) or SLOW (4) button on your 3Doodler.

To temporarily pause the continuous flow of plastic/filament, hold

down on either the FAST (3) or SLOW (4) button on your 3Doodler

and then release to resume continuous flow.

NOTE: Upon resumption of continuous flow, the extrusion

speed will change depending on which extrusion button

(FAST or SLOW) you used to pause the flow. The 10

minutes of continuous flow will restart after pausing.

Step 7: Unloading/reversing your plastic/filament

To unload the plastic:

1. Ensure that the device is still at the correct temperature required

for the type of plastic/filament being used:

LO ("Low") = GREEN LED indicator

Otherwise, please press one of the

extrusion buttons and wait for the

3Doodler to heat up again.

2. Hold down BOTH the FAST (3) and

SLOW (4) extrusion buttons at the

same time. The LED indicator (5) will

flash.

3. When the plastic/filament stops

moving in reverse you may gently

take it out from the back of the pen

Step 8: Power down

To safely turn the pen off, move the sliding switch to the OFF

position

. Allow the pen to cool completely before storing.

PRO-TIP:

Optimize your melt

temperature. Using the mini-screw

driver

, tweak your 3Doodler's melt

temperature +/- 5°C, for minor flow

adjustments and expertly consistent

Doodles. To do this, insert the mini

screw driver into the potted

Temperature Adjuster

panel. Turn the mini screw driver

clockwise to increase the melt

temperature, or anti-clockwise to

decrease the melt temperature.

PRO-TIP:

Speed boost! While the

HI ("High") = BLUE LED indicator

on the control