- ページ 8

アクセサリー 3Doodler 2.0のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。3Doodler 2.0 10 ページ。
3Doodler 2.0 にも：クイック・スタート・マニュアル (2 ページ), マニュアル (4 ページ)

4. Turn the pen off and allow it to cool down a little, but not fully.

Screw the nozzle on clockwise a few turns, but don't tighten it yet.

Turn the pen back on; once it's hot and the LED is either blue or

green, tighten the nozzle with the nozzle removal tool, stopping

when you first feel resistance. WARNING: DO NOT force the

nozzle or overtighten it, as you could irreparably damage your

3Doodler.

5. If you are still experiencing problems extruding or suspect there

may be a blockage in your 3Doodler, please remove the

Maintenance Cover

•

Ensure the LED light is BLUE or GREEN before starting this

process (indicating that the pen is hot)

•

Using metallic tweezers, lever up the two release hooks on

either side of the Maintenance Cover

•

Remove the Maintenance Cover by hand

•

Ensuring that the LED light is still BLUE or GREEN, use your

tweezers to grip and pull the plastic/filament away from the

nozzle of the pen, towards the back of the pen. Once loose,

and the end of the plastic/filament is visible inside the opening

of the pen, simply pull the plastic/filament out of the opening

using your tweezers

•

Replace the Maintenance Cover by inserting the latched

as follows:

Plastic/filament