- ページ 11
バイクアクセサリー ClearWater Lights GlendaのPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。ClearWater Lights Glenda 12 ページ。 Led light kit for bmw k1600gt
ClearWater Lights Glenda にも： インストレーション・マニュアル (12 ページ), インストレーション・マニュアル (12 ページ), インストレーション・マニュアル (12 ページ), インストレーション・マニュアル (16 ページ)
ページを印刷するHelpful Hints:
Using a Drip Loop:
• Though our lights are sealed for ultimate all weather use, sometimes
water sneaks by. To make sure this doesn't happen, we highly suggest
using a drip loop. When installing the wiring to your lights, use a drip
loop as shown below. This will keep water from dripping directly into the
light and instead fall off before it can reach the back of the body.
• To do this just leave a bit of extra wiring and let it hang below the light.
You could make a complete loop if you like, but just make sure the wire
hangs below the light as shown below.
Posi-Products Installation Instructions:
Posi-Twist (A):
1. Strip all wires to be inserted 1/2" .
2. Twist all wires together before inserting into the Posi-twist.
3. Completely unscrew the top from the Posi-twist.
4. Feed the twisted wires through the bottom portion of the Posi-twist.
5. Attach the top and tighten, while ensuring the wires do not slip out of
the bottom of the Posi-twist.
Posi-Tap (B):
1. Unscrew the cap of the Posi-Tap (gray or large end).
2. Slide the wire you wish to tap into through the slot in the cap.
3. Re-attach the body of the Posi-Tap and tighten.
4. Attach the other wire to the bottom using the same method as a Posi-Twist.
No Drip Loop
A
With Drip Loop
B
Page 11