- ページ 12

リフティングシステム ARTHUR HOLM AHDTLのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。ARTHUR HOLM AHDTL 20 ページ。 Universal motorized system for gooseneck microphones
ARTHUR HOLM AHDTL にも：ユーザーマニュアル (13 ページ)

ページを印刷する

Controls & Connectors

MICROPHONE LENGTH SETTING PROCEDURE

DynamicTalk is designed to work with microphones of different lengths. Two

signs to identify an incorrect setup of the microphone length are:

- The microphone do not goes down completely.

- The microphone goes down too slowly, and gets stuck inside.

The microphone length can be adjusted using the Monitor Configurator

Tool, but there is also a quick procedure that doesn't require the use of a

PC and cable:

1. Disconnect the Power connector

2. Set switch 5 to ON position

3. Set the length of the microphone in the rotatory switch,

in cm. For instance, if the microphone is 40cm, set the

rotatory switch as: tens=4, unit=0

4. Connect to Power. There will be a 5 beep sound

5. Disconnect Power

6. Set switch 5 to OFF position

7. Set the AHnet address in the rotatory switch, the default

setting is address 01 (tens=0, units=1).

8. Connect the Power connector