ページを印刷するNano Installation Guide
TakeOff Nano Hybrid
c)
b)
Bottom bracket with
teeth facing upwards
Top cap cover
Double
face tape
Déc. 2007
a)
Top bracket with teeth
facing downward
e)
Vertical Cap
(PECN180)
a) Use the Nano junction plates to join the 2 TakeOff
panels side by side.
b) Remove the top cap from the Nano screen
c) Install the hybrid TakeOff brackets into the vertical
profile of the Nano screen, being careful to follow the
direction of the teeth as in the drawing to the left.
Tighten them only enough to allow them to stay in place.
d) Bring the Nano screen towards the TakeOff panel and
insert the TakeOff brackets in the connector of the
TakeOff panel. Lift the bottom bracket and tighten the
screws, then tighten the screws in the top bracket.
a)
This junction plate
is to be inserted
between the panels.
e) Finishing:
Install the two top caps, the vertical connectors
and the top cap cover.
d)
pg.2