- ページ 10
照明器具 ALUZ A8-ZIZA-TAPEのPDF 取付説明書をオンラインで閲覧またはダウンロードできます。ALUZ A8-ZIZA-TAPE 11 ページ。 Led tape
ALUZ A8-ZIZA-TAPE にも： マニュアル (14 ページ)
ページを印刷するZIZA
Tape
A8-ZIZA-TAPE
1
Measure area where luminaire will be installed. Use a laser line to create
a reference line along installation area, ensuring consistent alignment
of mounting channels. Mark location where mounting channels will be
installed along reference line.
2
Lay extrusions along chalk line and drill at least 3 countersink holes per
extrusion. Drill additional holes as needed.
3
Screw extrusions to surface using countersink screws.
Note: Ensure extrusions are aligned. Misalignment will prevent lens from
snapping in.
Extrusions aligned
4
Install tube into extrusions, overlapping where two extrusions meet. Plan
your cuts so that the tube will always overlap where two extrusions meet.
Overlapping tubes helps keep extrusions aligned and prevents light leaks.
Countersink hole
Countersink screw
Install square tube
into extrusions
ALUZ
1170 North Red Gum Street, Anaheim, CA 92806
Phone: 800 921 2254 or 714 535 7900 | Fax: 714 535 7902 | [email protected] | aluz.lighting
© ALUZ All rights reserved. ALUZ reserves the right to make changes or withdraw specifi cations without prior notice.
Mounting Lightstrip (Wet Location Mounting Channel)
5
Ensure tube is secured in place.
6
If applicable, position jumper wires between luminaire segments as needed.
Note: Refer to Design Guidelines - Continuous Run (Wet Location) for details.
7
If applicable, connect disconnects between luminaires or solder connectors
using the steps from Application Guidelines.
8
Perform a continuity test before connecting luminaire to power source.
Installation Instructions
9 / 1 / 2021 / Rev 0
Page 10 of 11
Ensure tube is
secured in place