ALUZ A8-ZIZA-TAPE 설치 지침 매뉴얼 - 페이지 10

{카테고리_이름} ALUZ A8-ZIZA-TAPE에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ALUZ A8-ZIZA-TAPE 11 페이지. Led tape
ALUZ A8-ZIZA-TAPE에 대해서도 마찬가지입니다: 매뉴얼 (14 페이지)

ZIZA

Tape

A8-ZIZA-TAPE

Measure area where luminaire will be installed. Use a laser line to create

a reference line along installation area, ensuring consistent alignment

of mounting channels. Mark location where mounting channels will be

installed along reference line.

Lay extrusions along chalk line and drill at least 3 countersink holes per

extrusion. Drill additional holes as needed.

Screw extrusions to surface using countersink screws.

Note: Ensure extrusions are aligned. Misalignment will prevent lens from

snapping in.

Extrusions aligned

Install tube into extrusions, overlapping where two extrusions meet. Plan

your cuts so that the tube will always overlap where two extrusions meet.

Overlapping tubes helps keep extrusions aligned and prevents light leaks.

Countersink hole

Countersink screw

Install square tube

into extrusions

ALUZ

1170 North Red Gum Street, Anaheim, CA 92806

Phone: 800 921 2254 or 714 535 7900 | Fax: 714 535 7902 | [email protected] | aluz.lighting

Mounting Lightstrip (Wet Location Mounting Channel)

Ensure tube is secured in place.

If applicable, position jumper wires between luminaire segments as needed.

Note: Refer to Design Guidelines - Continuous Run (Wet Location) for details.

If applicable, connect disconnects between luminaires or solder connectors

using the steps from Application Guidelines.

Perform a continuity test before connecting luminaire to power source.

Installation Instructions

9 / 1 / 2021 / Rev 0

Page 10 of 11

Ensure tube is

secured in place