ページを印刷するNOTE:
The information contained in this Manual is designed to assist you in the safe maintenance of
the Nailer.
Some illustrations in this Manual may show details or attachments that differ from those on
your own Nailer.
MAINTENANCE AND INSPECTION
Read section titled "SAFETY" (pages 3 – 5).
WARNING
Disconnect air hose and remove all pins from
Nailer when:
1) doing maintenance and inspection; and
2) clearing a jam.
1. Clearing a jam
Remove a jammed pin in the following order :
1 DISCONNECT AIR HOSE.
2 Open the nail guide.
3 Insert a rod into the outlet.
Tap the rod with a hammer.
Hammer
Rod
Outlet
4 Remove the jammed pin with a slotted screw
driver.
Pin
5 Cut the deformed collated wire with nippers.
Correct the deformation.
6 In case of frequent jam, contact an authorized
service center.
MAINTENANCE
1
Disconnect
air hose
Nail Guide
Slotted Screw Driver
2. Inspecting the push lever
1 DISCONNECT AIR HOSE.
2 Clean the push lever sliding part.
Lubricate it with pneumatic tool lubricant.
Nose
Push
Lever
3. Inspecting the feeders
1 DISCONNECT AIR HOSE.
2 Clean the knob sliding part.
Lubricate it with pneumatic tool lubricant.
3 Open the nail guide and remove dust.
Lubricate the sliding groove of the feeder and
shafts.
CAUTION
Check that nail stopper (A) and nail stopper (B) slide
smoothly by pushing them with finger.
If not smooth, pins can be driven at an irregular angle
and hurt someone.
— 14 —
1
Disconnect
air hose
Lubricate
1
Disconnect
air hose
Nail
Knob
Guide