ページを印刷するNail Stopper (A)
Nail guide
Nail Stopper (B)
4 Lubricate the feeding surfaces of the nose and the
nail guide after cleaning.
This promotes smooth operation and prevents rust.
4. Inspecting the magazine
1 DISCONNECT AIR HOSE.
2 Clean the magazine. Remove dust or wooden tips
which may have accumulated in the magazine.
5. Storing
When not in use for an extended period, apply a thin
coat of the lubricant to the steel parts to avoid rust.
Do not store the Nailer in a cold weather environment.
Keep the Nailer in a warm area.
When not in use, the Nailer should be stored in a warm
and dry place.
Keep out of reach children.
6. WARNING LABEL
Change the WARNING LABEL if missing or damaged.
A new WARNING LABEL is available from an
authorized service center.
7. Maintenance chart (See page 16)
8. Operator troubleshooting (See page 16)
Shaft
Feeder
Nose
Warning
Label
— 15 —
SERVICE AND REPAIRS
WARNING
Only service personnel trained by ET&F, distributor
or employer shall repair the Nailer.
Use only parts supplied or recommended by ET&F
for repair.
All quality Nailers will eventually require servicing or
replacement of parts because of wear from normal use.
NOTE:
Specifications are subject to change without any
obligation on the part of ET&F.