ACR Electronics OLAS CORE 빠른 시작 매뉴얼 - 페이지 7

{카테고리_이름} ACR Electronics OLAS CORE에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ACR Electronics OLAS CORE 12 페이지. Testing the alarm
ACR Electronics OLAS CORE에 대해서도 마찬가지입니다: 정확도 테스트 (2 페이지), 설정 및 범위 테스트 (4 페이지), 문제 해결 (2 페이지), 매뉴얼 (2 페이지), 설정 및 범위 테스트 (4 페이지)

페이지 인쇄

4. OLAS MOBILE APPLICATION FEATURES (AVAILABLE FROM HOME SCREEN)

• Customise the OLAS transmitters name (press the unique number associated with the transmitter ~ eg.

OLAS Float-On 1670 - then type the custom name)

• Check OLAS tag battery status

• Enable/Disable OLAS transmitters

• Pause all tracking

5. PAUSE TRACKING

• Press the control switch for 2 seconds, release the control switch after a single beep

• When in Paused state the control switch will flash Red for 3 seconds ON/3 seconds OFF followed by a

sound signal

• Press the control switch once to re-start Tracking

• If an OLAS transmitter has been removed or switched off the Core will remain in Pause

6. ADDING AN OLAS TRANSMITTER (WITHOUT THE OLAS APP)

• Press the control switch for 2 seconds, release after a single beep, Tracking will be Paused

• Switch on the OLAS transmitter and hold it within 2 meters of the Core

• Press the control switch once, the control switch will flash Red for 10 seconds whilst scanning for new

transmitters

• The number of connected OLAS transmitters is indicated with a sound signal and Red flash per

transmitter

7. ADDING AN OLAS TRANSMITTER (WITH THE OLAS APP)

• Switch on the OLAS transmitter and hold it within 2 meters of the Core

• Open the home screen, press the + icon in the bottom corner, press "Scan for new transmitter"

• The control switch will flash Red for 10 seconds whilst scanning for new transmitters

• The number of connected OLAS transmitters is indicated with a sound signal and Red flash per

transmitter

• The home screen will update with the newly connected transmitters

8. REMOVE AN OLAS TRANSMITTER

• Press the control switch for 4 seconds, release after the second beep – this will switch off the Core

• Switch off the OLAS transmitter/s to be removed. OLAS transmitter are turned off by pressing the button

on the transmitter for 4 secs. The light on the transmitter will then flash red.

• Hold all remaining OLAS transmitters within 2 meters of the Core

• Press the control switch to switch the Core ON

• The Core will scan for 30 seconds while the control switch LED flashes Red to indicate scanning

• After 30 seconds, any OLAS transmitter within 2 meters of the Core will be tracked

• The number of connected OLAS transmitters is indicated with a sound signal and Red flash per

transmitter

• The control switch will illuminate Red to indicate the Core is Tracking