Floe VSD6500 조립 지침 - 페이지 8

{카테고리_이름} Floe VSD6500에 대한 조립 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Floe VSD6500 12 페이지. Full length pontoon & tri-toon bunks large lifts
Floe VSD6500에 대해서도 마찬가지입니다: 조립 지침 매뉴얼 (8 페이지), 조립 지침 매뉴얼 (16 페이지)

Floe VSD6500 조립 지침
Step 4
Attach the 118" rear frame beam to the
assemblied side frames using (4) 1/2" x
4" bolts, (8) flat washers, and (4) nylock
nuts. See Fig. 4A. The front frame beam
is attached the same as the rear but use
(2) 1/2" x 4" bolts in the top holes only.
See Fig. 4B.
The bolts in the bottom holes will be
installed in a later step.
At this time you need to square the frame.
Using a framing square as shown in Fig.
4A & 4B gradually tighten each bolt a little
at a time, and alternate checking for
squareness at all corner posts. Torque all
clamp bolts to 80 ft/lbs.
1/2" x 4" Bolt
w/ Flatwashers,
& Nylock Nut
Fig. 4B
Framing
Square
1/2" x 4" Bolts
w/ Nylock Nuts
Fig. 4B
Fig. 4A
SHEET 8 OF 12
Fig. 4A
Framing
Square
1/2" x 4" Bolts
w/ Nylock Nuts
1/2" x 4" Bolts
w/ Flatwashers,
& Nylock Nuts