Coalesse Topo 조립 지침 매뉴얼 - 페이지 7
{카테고리_이름} Coalesse Topo에 대한 조립 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Coalesse Topo 10 페이지. Biplane
페이지 인쇄9.
Slide PVD shelf into fixed shelf assembly (9a). Align entire
shelf assembly with worksurface and feed bolts through (9b).
Check height of PVD shelf relative to the fixed shelf. If
uneven, loosen bolts on bushings, make appropriate
adjustments to the height and retighten bolts (9c). Secure
bolts to the fixed shelf assembly from underneath worksurface
using two (2) hex flange nuts (9d). Locate PVD shelf relative
to fixed shelf by aligning front (9e) and secure remaining bolts
to the PVD shelf from underneath worksurface using two (2)
hex flange nuts (9f). Do not over tighten.
Reach under PVD top and place provided bumpers on PVD
shelf bracket as shown (9g).
NOTE: You may need to adjust workstation to its longest
length in order to access the hex flange nuts.
9g
PVD SHELF
9a
FIXED
SHELF
ASSEMBLY
9b
VIEW LOOKING
UNDERNEATH REAR
WORKSURFACE
9d
TOP VIEW OF DESK
ALIGN
9e
ALIGN
FIXED SHELF
ASSEMBLY
REDUCE GAP
9f
HEX FLANGE NUT
PVD SHELF
BOLTS TO
LOOSEN
9c
Page 7 of 10
939500422 Rev D