Canon AE-1 설치 절차 매뉴얼 - 페이지 8

{카테고리_이름} Canon AE-1에 대한 설치 절차 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Canon AE-1 48 페이지.
Canon AE-1에 대해서도 마찬가지입니다: 시작하기 (2 페이지), 사용 설명서 (22 페이지), 매뉴얼 (42 페이지), 매뉴얼 (12 페이지), 사용 설명서 (22 페이지)

Canon AE-1 설치 절차 매뉴얼
1.3
Installing the Buffer
5) Remove all packing tape from the buffer pass unit.
6 ) Place the buffer pass unit on the delivery tray, and
Pass Unit
connect the connector [l] to the host machine.
7) Match the claw of the buffer pass unit against the
1) Detach the blanking part [I] from the rear internal
connecting assembly [2], and secure the buffer pass
cover and the blanking part [2] of the delivery tray,
unit in place using two screws [3] (tapping; M4 x
by disengaging the claw using a flat-blade screw-
12).
driver.
2) Detach the blanking part [3] using a flat-blade
screwdriver or the like.
3) Remove the paper full sensor flag [4] for delivery
tray 1.
Do not remove the paper full sensor flag [5] for de-
livery tray 2.
4) Remove the paper full sensor flag for delivery tray
1, and then attach the cover [3].
A
When the cover [3] is not attached, remove the fol-
lowing parts:
Host machine's front cover (one blanking rubber
and two screws)
Host machine's delivery tray (two screws)
Host machine's rear cover (four screws)
Next, remove the paper full sensor flag [4] for de-
livery tray 1 and then attach the cover in place.
When installing the buffer pass unit, take care not
to break [4] of the sensor flag for delivery tray 2.