AMERICANA OZARK 조립 지침 매뉴얼 - 페이지 3

{카테고리_이름} AMERICANA OZARK에 대한 조립 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AMERICANA OZARK 7 페이지. Door canopy

STEP 1.

-Drill 1/4" dia. holes beginning 2" from either end at 12" to 16" on center in awning rail as shown (see Fig. 1-1).

-Slide awning rail onto wall channel and apply a generous bead of silicone to backside of awning rail (see Fig 1-1).

Note: Center to center dimension of 1/4" holes is determined by location of wall studs or other structural member that the

awning must be anchored to. Do not attach awning to sheeting, siding, flashing, or any other non-structural surface.

-After the mounting channel is installed, apply caulk to the hinge to prevent water leaks.

-Mark a level line a minimum of 5 1/2" above out-swinging door.

-Align holes in awning rail with level line, and attach awning rail / mounting channel assembly to existing structure with

1 1/2" lag screws (see Fig. 1-2).

NOTE: If attaching patio cover to concrete or masonry unit, a masonry drill, bit, and anchors are required.

Mounting Channel

1 1/2" Lag

Screw (Masonry

Anchors if Req'd)

Fig. 1-2

Apply Silicone to

Backside of Rail

Awning Rail

Fig. 1-1