astra telematics AT210 빠른 시작 매뉴얼 - 페이지 4

{카테고리_이름} astra telematics AT210에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. astra telematics AT210 4 페이지. Vehicle tracking device
astra telematics AT210에 대해서도 마찬가지입니다: 사용자 설명서 (9 페이지), 설치 매뉴얼 (5 페이지)

페이지 인쇄

7. Configure Settings

a. Once the device is running and you can see output text scrolling in TeraTerm, you are

ready to configure the device by typing or pasting commands into the TeraTerm

window (note: these commands can be send by SMS also).

b. Configure GSM/GPRS network operator APN settings to suit your SIM using the

following commands:

$APAD,<apn_address>

$APUN,<apn_username>

$APPW,<apn_password>

if you dont know the appropriate APN settings for the network operator you are

using, you can look them up from:

c. Configure your server IP Address (or hostname) and port. This is the destination that

the AT210 will deliver data reports via TCP or UDP socket connections. The

commands are:

$IPAD,<ip_address_or_hostname>

$PORT,<port_number>

NOTE: IP address should be entered WITHOUT LEADING ZEROS

d. Select the required reporting protocol (i.e. packet format) using one of the following

commands:

$PROT,6

$PROT,16,<mask>

please contact Astra Telematics for advice and documentation on the above

protocols

e. Your AT210 is now configured will all the basic essentials for operation. The text

output in TeraTerm will show details of any errors.

f. Alternatively, use the $TEST command (send through TeraTerm or by SMS) to confirm

correct device operational status. The reply is user-readable and self-explanatory, but

you can find an application note with details on our website downloads page.

g. Note that the AT200 will not attempt to send any data until it has a good GNSS fix.

f. Please refer to the AT210 User Guide and various application notes for further details

of features and configuration options.

http://www.taniwha.org.uk/gprs.html

protocol 'K'

protocol 'X' (define <mask> to select required modules)