DoorHan PCB-SH 프로그래밍 지침 매뉴얼 - 페이지 11

{카테고리_이름} DoorHan PCB-SH에 대한 프로그래밍 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DoorHan PCB-SH 12 페이지. Control board
DoorHan PCB-SH에 대해서도 마찬가지입니다: 프로그래밍 지침 매뉴얼 (14 페이지), 프로그래밍 지침 매뉴얼 (16 페이지)

페이지 인쇄

5. Then on a new transmitter press twice the button that you wish to control the operator. The Remote indicator will flash red

once to confirm that the receiver has learned the transmitter code.

NOTE. Perform transmitters programming within operating range of the operator receiver. The number of each button

can be determined by the dots on the transmitter body.

3.5. DISABLING OF REMOTE PROGRAMMING FUNCTION (FOR 1.1 SOFT ONLY)

If the function is enabled then the Remote indicator switches on and off once. If the function is disabled then the Remote

indicator won't switch on.

To enable / disable the function press and hold the R button, then supply power to the control board without releasing the

button.

3.6. MARKING OF DOORHAN TRANSMITTERS BUTTONS

TRANSMITTER PROGRAMMING