DoorHan PCB-SH380 빠른 시작 매뉴얼 - 페이지 3

{카테고리_이름} DoorHan PCB-SH380에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DoorHan PCB-SH380 8 페이지. Control board

1.2. CONTROL BOARD TERMINAL BLOCKS

1. Connection of supply voltage (X2 terminal block)

400 V supply voltage connect to terminals «PE», «N»,«L1», «L2», «L3».

NOTE. If, after mounting the operator it moves down when the «UP» button is pressed, the positions of L1 and L2 must

be reversed.

2. Motor (X1 terminal block)

Connect the motor to terminals «W», «V» and «U». 400V motor: max. operating current < 9 A, wattage ≤ 4 kW.

3. Limit switches (X6 terminal block)

Connect the «CL» (closing switch), «OP» (opening switch) limit switches and «GND» (common wire).

4. 3-position control post, key-switch and safety devices (X4, X5 and X6 terminal blocks)

Connect the 3-position control post to the terminals «OPEN», «STOP», «CLOSE» and «GND».

Connect the key-switch to terminals «SBS» and «GND».

Connect the output contacts of the safety devices to the terminals «Ph.CL» and «GND»

WARNING!

If 3-position control post and safety devices are not used, install a jumper between «STOP», «Ph.CL» and «GND».

Voltage: 400V

3~Motor: 400V

Key-switch

3-button control station and safety devices

CONTROL BOARD