Astralpool DMX 설치, 운영 및 유지보수 매뉴얼 - 페이지 15

{카테고리_이름} Astralpool DMX에 대한 설치, 운영 및 유지보수 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Astralpool DMX 18 페이지. Variable pump

WARNING: Protect the water outlet from wind and do not operate in strong wind. If

the unit is installed in a windy area, water outlet could be often displaced.

3.1

OPERATION

The operation of the unit will depend on the control system installed, which is

not supplied with this unit.

A DMX/RDM controller with its respective software is required. We use these

ones to configure the channels and directions of DMX that we will use in our

equipment in a bidirectional way.

For the correct use of the pump, two different DMX channels are required.

Channel 1 is used to activate de pump:

0 - 127 : Pump OFF.

127 – 255: Pump ON

Channel 2 is used for the analog output. With this channel we can configure the

height of the water jet.

WARNING: The maximum work cycles of the pump are 60 starts/hour.

WARNING: Use the equipment only to pump water with the characteristics described

in section 1.2.

WARNING: Do not operate the pump until the water level is 25 cm above the highest

point of the pump.

3.2

WARNING: Risk of dead due to electric shock. Disconnect the equipment from the

main power supply before performing any maintenance.

For the maintenance of the components made of stainless steel, see the manual

attached.

It is highly recommendable to activate the device at least once a week to check the

proper operation.

Clean the pre-filter of the pump at least once a week.

NOTE: The cleaning frequency of the pump pre-filter will depend on the conditions

in which the installation is.

INSTALLATION, OPERATION AND MAINTENANCE MANUAL; DMX VARIABLE PUMP

[en]

Fountain Units