Cognex DataMan 8600 Series 빠른 참조 매뉴얼 - 페이지 3
{카테고리_이름} Cognex DataMan 8600 Series에 대한 빠른 참조 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cognex DataMan 8600 Series 8 페이지. Handheld verifier
Cognex DataMan 8600 Series에 대해서도 마찬가지입니다: 참조 매뉴얼 (14 페이지)
페이지 인쇄
8600 Series Handheld Verifier Kit Contents
8600 verifier stand-off
COGNEX
®
DataMan™ 8600 Series
Handheld Verifier
Quick Reference Guide
LASER LIGHT, DO NOT STARE INTO BEAM: CLASS 2 LASER PRODUCT
FAILURE TO FOLLOW THESE INSTRUCTIONS MAY CAUSE SERIOUS INJURY
1
COGNEX
DataMan™ Verifier Calibration Card
Instructions:
CALIBRATION
1. Center calibration
TARGET
target in the field
of view
2. Depress and hold
reader trigger until
calibration routine
is complete
Lot Number 20061102
Calibration card
(stored in protective sleeve)
This document
NOTE: Refer to your DataMan 8600
Quick Reference Guide for information
on initial setup and establishing commu-
nication with the reader itself, as well as
compliance information.
Data Matrix Symbol Quality Verification
Cognex DataMan 8600 handheld verifiers ensure that a Data Matrix sym-
bol meets the AIM DPM (Direct Part Mark) Quality Guideline.
The DataMan 8600 handheld verifiers provide:
• Contract Compliance: The DataMan 8600 software, integrated lighting,
and fixed optics meet the AIM DPM Quality Guideline.
• System Calibration: The DataMan 8600 verifier includes a certified cali-
bration card necessary to calibrate the reader.
Upgrading a Device for Verification
If you are upgrading a previously purchased DataMan 8600 reader
to be used as a verifier, your reader must be using firmware version
5.4.0 CR1 at a minimum. To update the firmware:
1. Connect your reader to the DataMan Setup Tool.
2. Choose System->Update Firmware.
3. Select the file DM8600_v5.4.0_cr1.bin.gz from the directory where
the firmware update automatically navigates (Cognex\DataMan\
Firmware\DM8000 Series).
To enable the DPM Verification feature, you must upload a feature key
file to the reader:
1. Connect the reader to the DataMan Setup Tool.
2. Choose System->Upload Feature Key
3. Select the feature key file that you receive from Cognex.
4. The reader automatically reboots after the upgrade and it is ready
to use for verification.
2