Cognex DataMan 8600 Series 빠른 참조 매뉴얼 - 페이지 4

{카테고리_이름} Cognex DataMan 8600 Series에 대한 빠른 참조 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cognex DataMan 8600 Series 8 페이지. Handheld verifier
Cognex DataMan 8600 Series에 대해서도 마찬가지입니다: 참조 매뉴얼 (14 페이지)

페이지 인쇄

Getting Started: Stand-off Distances

The stand-off is an accessory that consists of a plastic frame that is attachable

to the device (see below) and various spacers. By threading in the right spac-

ers, different fixed mechanical reading distances can be set.

With a combination of 5mm, 7mm, and 10mm spacers, the following reading

distances can be set:

• 8,3 mm

(without spacer – 30° illumination)

• 13,3 mm

• 15,3 mm

(45° illumination - same distance as

DM7500 Verifier stand-off)

• 18,3 mm

NOTE: If 5mm spacers are used in combination with other spacers, the 5mm spacers

must be placed on top due to their shorter internal thread.

NOTE: 8.3 mm distance is required for AIM-DPM verification.

• 20,3 mm

• 23,3 mm

•

25,3 mm

(60° illumination)

•

30,3 mm

Getting Started: Stand-off Installation

Attach the stand-off carefully to your DataMan 8600 reader.

This way up

The stand-off

snap-fits into the

reader.