Cognex DataMan 8600 Series 빠른 참조 매뉴얼 - 페이지 5
{카테고리_이름} Cognex DataMan 8600 Series에 대한 빠른 참조 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cognex DataMan 8600 Series 8 페이지. Handheld verifier
Cognex DataMan 8600 Series에 대해서도 마찬가지입니다: 참조 매뉴얼 (14 페이지)
페이지 인쇄
Getting Started: Calibration
1.
Start the DataMan Setup Tool and connect to your reader.
2.
Select the Code Quality Settings task pane.
3.
Place the verifier against the calibration card with the symbol
centered below the reader, and squeeze the trigger.
4.
Continue squeezing the trigger. Calibration can take several seconds.
The Setup Tool displays a graphic guide if the symbol is not precisely
aligned with the reader; adjust the position and rotation of the reader
until the center of the
red rectangle
and there is no more than 10 degrees rotation between the symbol and
the reader. The reader beeps once when calibration is complete.
5
lies inside the
green rectangle
Code Quality: Verification
In order to perform Direct Part Mark Verification, your reader must be
calibrated as described in the previous section. To read symbols and view
verification results, perform the following steps:
1. Start the DataMan Setup Tool and connect to your reader.
2. Enable the Turn Code Quality On/Off icon in the tool bar.
NOTE: You can activate Code Quality mode by navigating to the Code Quality Settings pane
and ticking the Code Quality Enabled box.
3. Select the Results Display task pane.
4. Place the verifier against the symbol and squeeze the trigger. The sym-
bol must be centered within the field of view, and the reader must be
perpendicular to the surface containing the symbol and at the correct ro-
tation. If the reader is out of position, the Setup Tool displays this guide:
The verifier stand-off must be used to ensure correct symbol presenta-
tion and lighting requirements for the AIM DPM Quality Guideline.
5. Move the reader until the center of the red rectangle lies within the
green target rectangle. The reader beeps to indicate that the symbol has
been read and verified.
6