Akw M11 DigiPump 설치 및 사용자 관리 지침 - 페이지 4

{카테고리_이름} Akw M11 DigiPump에 대한 설치 및 사용자 관리 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Akw M11 DigiPump 20 페이지.

Mechanical And Plumbing Installation

Positioning

The AKW M11 DigiPump shower waste water pump must be installed by a

suitably qualified, competent person eg. NIC EIC, in accordance with current IEE

Wiring Regulations (BS7671), building regulations and local by-laws.

This product is rated at IP45 and suitable to be installed in Zone 1 or Zone 2

of a shower room only if these instructions are fully complied with.

The unit must be located away from the direct line of water jets.

Note: Zone 1 lies above zone 0 and below 2250mm (88in) vertically above a shower

tray or wet floor area.

The perimeter of zone 1 of a wet floor is within a 1.2 metres (47in) radius of the

shower head position. Consult BS7671 for further clarification.

FOR GUIDANCE ONLY- PLEASE REFER TO BS7671 FOR FURTHER DETAILS