Canon CN10x25 IAS S/E1 운영 매뉴얼 - 페이지 22

{카테고리_이름} Canon CN10x25 IAS S/E1에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Canon CN10x25 IAS S/E1 34 페이지. Zoom lens

페이지 인쇄

5 OPERATION

Framing Preset [Zoom]/[Focus]]/[Z+F] Setting

NOTE

The figure below is shown as an example. Actual state of the switch may look different if the function is al-

located to the different switch.

Fr1P function--------Assigned to the AUX switch by factory default.

1.　Setting the framing memory position

Zoom Rocker Seesaw

MEMO

Switch

Fr1P Switch

2.　Moving to the framing memory position

Once the Fr1P switch is pressed, the zoom starts to move toward the framing memory position at the preset speed.

When the zoom reaches to the framing memory position, it stops and stays there.

3.　Canceling the movement to the framing memory position or switching to other zoom operation.

During movement to the framing memory position, the movement can be canceled and/or switched to other zoom

operation by any of the following operations.

[Zoom Framing Preset]

• Pressing the Fr1P switch again.

• Zoom operation with the zoom rocker seesaw can

immediately take over.

• Zoom operation with the Shtl switch can im-

mediately take over.

5-2. FOCUS OPERATION

5-2-1. Manual Focus Operation

FOCUS

MANU. SERVO

REMOTE1

REMOTE2/

VIRTUAL

Focus Operation Change-over Knob

Shtl Switch

ZOOM

MANU.

SERVO

REMOTE3

Zoom (and focus) to the position that you want to store, while

holding this zoom (and zoom focus) position, press the Fr1P

switch while holding down the MEMO switch.

NOTE

This framing memory position is different from the shut-

tle memory position (Refer to "5-1-5. Suttle-Shot Func-

tion").The stored zoom position remains in the memory,

even after the power is turned off.

[Zoom, Focus Framing Preset]

• While is RET switch is held down, the on-air picture

(returned picture) can be viewed in the viewfinder.

　If the manual focus operation is performed, set the focus op-

eration change-over knob to MANU. position.

NOTE

The lens may be damaged if the focus ring is turned

forcibly with the knob at the SERVO position.

E16