DOREMIDI FC-3 사용 설명서 - 페이지 4

{카테고리_이름} DOREMIDI FC-3에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. DOREMIDI FC-3 8 페이지. Midi foot controller

 USB connection status: After the USB device is connected, it will display "D", and

after the USB HOST is connected, it will display "H".

 Switch pedal parameters: display the MIDI message type (PC/CC/NOTE) of the

switch pedal, and display the value after the pedal is pressed.

 Expression

(CC/NOTE/PBend/CPress) of the expression pedal, and display the value after the

pedal is pressed.

 MIDI message serial number: FC-3 can be configured with 1~16 independent MIDI

message groups. Hold down "Shift" and click "-"/"+" to switch to select different

MIDI message sequence numbers.

(Note: CC: Continue Control, PC: Program Change, PBend: Pitch Bend, CPress: MIDI Channel

Pressure)

5. Configure pedal MIDI messages

Connect the Expression Pedal: If you need to configure the Expression Pedal, please

connect the Expression Pedal first, and then perform the following operations.

Connect to the computer: connect to the computer through the USB DEVICE interface,

after the connection is successful, the indicator light is always on, and the display

shows "D".

(Note: Generally speaking, the computer has its own MIDI driver. If you find that the

computer does not have a MIDI driver, you need to install the MIDI driver. Installation method:

https://windowsreport.com/install-midi-drivers-pc/)

Open the configuration software (Pedal Config Tool V2.0), the interface is as follows:

pedal

parameters:

display

the

MIDI

message

type