Cansec MAP2 설치 매뉴얼 - 페이지 13
{카테고리_이름} Cansec MAP2에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cansec MAP2 16 페이지. Elevator control
페이지 인쇄
MAP2 PLM COMMUNICATION
MAP2 to H1000 Panel Communication LEDs
If the MAP2 elevator control panel has been correctly configured as a 32 to 64 floor
elevator system, the two LEDs on the Panel Logic Module (PLM) daughter board will
indicate the RS485 communication to the auxiliary H1000 panels. The PLM LEDs are
labeled TX485 (Green LED1) and RX485 (Red LED2). If no auxiliary H1000 panels are
connected to the MAP2 elevator control panel, the TX485 (Green LED1) will toggle On
and Off. If all the auxiliary H1000 panels are configured and connected correctly, both
TX485 (Green LED1) and RX485 (RED LED2) will toggle On and Off.
TX485 LED
RX485 LED
MAP2 Elevator Control
Page 13 of 16
Installation Guide
April 2020 • Rev. 1.0