Battle Creek 2852 사용 설명서 - 페이지 3

{카테고리_이름} Battle Creek 2852에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Battle Creek 2852 16 페이지. Heat therapy pad

Using Your Custom-Touch

™ Heat Pad

Slide the Custom-Touch™ heating unit into the special Moisture-

Plus!™ cover provided with your system. Do not use without the

cover, and do not add additional layers of insulating cover.

The outer cover is designed to absorb moisture from the atmo-

sphere between uses and release the moisture when the heat is

activated. Your skin should feel slightly damp from the water va-

por condensed during the treatment, but will not be dripping wet.

If you feel your cover is not producing enough moisture, the steps

below will show you how to safely add a damp cloth.

1. Start by laying the MoisturePlus!™ cover out flat and smooth.

This type of cover is sometimes called a "stupe" cover (sounds like

"stoop"), since it allows you to add moisture, if needed, without

getting the fabric of the heat pack wet.

2. Slide the Custom-Touch™ heat pack into the bottom section of

the cover, under the white nylon layer. Make sure the heat pack is

kept smooth and flat inside the cover.

3. Slightly dampen a cloth or towel (a fleece square is included

for your convenience) and squeeze out the excess moisture. Slide

the damp cloth into the top section of the cover, over the white

nylon layer. The nylon layer is necessary to protect your Custom-

Touch™ heating unit from becoming damp. The cloth should not

be wet, just damp. It does not need to fill the entire area of the

vinyl pocket, but should be flat and smooth.

It is very important to keep the heating unit flat inside the cover.

Folded or overlapping areas of the heating unit could intensify the

heat. This could damage the unit, burn the user or cause a fire.

Feel inside the cover with your hand to make sure the heating unit

is flat and wrinkle-free. Before each use, check the heating unit to

be sure it has remained flat inside the cover.

Insert the plug into any convenient 110-volt outlet. The pack has

a polarized plug (one blade is wider than the other) as a safety

feature. This plug will fit into a polarized outlet only one way. If

Page 2