Dot Origin VTAP100-PACS 설치 매뉴얼 - 페이지 7

{카테고리_이름} Dot Origin VTAP100-PACS에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dot Origin VTAP100-PACS 14 페이지. Mobile nfc pass reader

3 Mechanical installation

The VTAP100 unit for OEM integration comprises a PCB with an integral antenna.

WARNING: Observe all

There is more detailed information in the next section about how to fit the VTAP100 unit inside the

Optional wallbox

Connect the PCB to a PC using only a MicroUSB to USB cable, or the optional captive USB cable, if

any. (Never connect both at the same time).

The VTAP100-PACS model can alternatively be powered by connecting it to an access controller,

using the Wiegand connector supplied (see .

The VTAP100 is rated at 5V DC @ 50 to 150mA for power over USB. When powered over Wiegand it

is rated at 8V DC @ 30 to 100mA

The VTAP100 must be stored and operated under the following conditions:

Ambient temperature 0 to +50degC

Humidity 0 to 95% RH non-condensing

Pressure 86-106kPa

VTAP100-PACS V3A INSTALLATION GUIDE

Figure 3-1 VTAP100 components

Safety instructions

case, if used.

when installing the VTAP100 PCB.

PAGE 3