Electrex Rexcon Die Sentry 매뉴얼 - 페이지 14

{카테고리_이름} Electrex Rexcon Die Sentry에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Electrex Rexcon Die Sentry 14 페이지.

base timing) or TIME (TIME base timing) for examine window.

PROBLEM: PRESS STOPS AFTER BDC (BOTTOM DEAD

CENTER)

CAUSE: REMEDY:

1. Low counterbalance pressure. Adjust pressure.

2. Feeder feeding too late in cycle. Adjust feeder to advance

material as soon as possible at low speed (stroke per minute) of

press.

3. Excess travel on Clutch/Brake of press. Adjust Clutch/Brake air

pressure to proper setting.

Adjust Clutch/Brake braking pads.

Determine if Clutch/Brake Assembly needs repair.

Slow press down.