Doug Fleenor Design E2E 구성 매뉴얼 - 페이지 7
{카테고리_이름} Doug Fleenor Design E2E에 대한 구성 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Doug Fleenor Design E2E 8 페이지. Ethernet to ethernet protocol converter
페이지 인쇄Example 2 – No Traffic Separation – sACN system with ArtNet dimmer:
When there is a single router in a system, and network traffic is not a concern, both the Ethernet
in and Ethernet out may be connected to the router. The router will issue IP addresses to all of
the DHCP enabled devices on the network, and Node Discovery will be able to see both
interfaces on the E2E. The network usage is doubled for each universe going into the E2E in
port. This is represented with the black/red lines in the below diagram. In cases where the
network uses static addressing, or the light board provides a DHCP server, the Ethernet router
should be changed to an Ethernet switch in the example below.
Figure 4: Single Network described in Example 2
Page 7 of 8