Doug Fleenor Design DMX24DIM-2U 설치 및 운영 매뉴얼 - 페이지 4

{카테고리_이름} Doug Fleenor Design DMX24DIM-2U에 대한 설치 및 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Doug Fleenor Design DMX24DIM-2U 5 페이지.

Setting the address switches

The front panel address switches are used to select the DMX512 starting address for the DMX24DIM

or DMX24DIM-2U. Any starting address from 1 - 512 can be selected. The address shown on the

switches will be the DMX512 address for the first dimmer output. The next 23 consecutive DMX512

levels will be applied to the remaining dimmer channels.

When the address switches are set to 000, the DMX24DIM or DMX24DIM-2U operates as if the

address switches were set to 001.

The address switches are also used for a local test function described below.

Local control mode is used to turn on an output without the use of a DMX512 signal source. To use

local control, set the DMX address switches to 601 to turn on channel 1, 602 for channel 2, etc.

The LED indicators on the front of the DMX24DIM or DMX24DIM-2U have the following functions:

LED label

Function

SIGNAL

On when DMX is present, flashes when local control is active

MIMIC 1

Tracks the current level of dimmer 1 for troubleshooting purposes

PWR

On when power is on

Loss of DMX512 signal

Upon loss of the DMX512 input, the DMX24DIM will begin fading all of its outputs to zero. The fade

out time is about 60 seconds from the loss of signal.

Page 4 of 5