Baumer Hubner Berlin PMG10 설치 및 작동 지침 - 페이지 14

{카테고리_이름} Baumer Hubner Berlin PMG10에 대한 설치 및 작동 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Baumer Hubner Berlin PMG10 32 페이지. Absolute encoder
Baumer Hubner Berlin PMG10에 대해서도 마찬가지입니다: 설치 및 작동 지침 (32 페이지), 운영 매뉴얼 (44 페이지)

페이지 인쇄
Baumer Hubner Berlin PMG10 설치 및 작동 지침
MOUNTING
4.3
Maximum permissible mounting tolerance when the Baumer Hübner K 35 spring
disk coupling is used
Devices with a solid shaft should be driven through the Baumer Hübner K 35 spring disk
coupling (accessory), that can be pushed onto the shaft without axial loading�
i
The figure below shows the device with EURO flange B10, the same maximum per-
missible mounting tolerances are valid with the device with housing foot B3�
)
The device must be mounted on the drive with the least possible angular error and
parallel misalignment�
)
Risk of damaging the ball bearings
Coupling components must not be driven onto the shaft with improper force (e� g�
hammer impacts), because of the risk of damaging the ball bearings�
Admissible
parallel misalignment
* With insulated hub
All dimensions in millimeters, unless otherwise stated�
11/27
2-10
Admissible
angular error
MB253EN - 11173971, 19A2, Baumer_PMG10-DeviceNet_II_EN
Admissible
axial movement
±0�7 (±0�3*)