Baumer HUBNER BERLIN PROFI NET microGen HMG10P 운영 매뉴얼 - 페이지 29
{카테고리_이름} Baumer HUBNER BERLIN PROFI NET microGen HMG10P에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Baumer HUBNER BERLIN PROFI NET microGen HMG10P 44 페이지. Incremental encoder with magnetic sensing
Baumer HUBNER BERLIN PROFI NET microGen HMG10P에 대해서도 마찬가지입니다: 설치 및 작동 지침 (32 페이지), 설치 및 작동 지침 (40 페이지)
페이지 인쇄
Baumer Hübner
6.2.3
Switching level additional output incremental (optional)
Switching level
High/Low
Transmission length
Output frequency
I
The TTL/HTL output (Vin = Vout) at the additional incremental output is galvanically isolated
and requires separate voltage supply.
Tab. 1: Switching level additional output incremental (optional)
6.2.4
Programming interface (only for programmable variant)
Encoder parameters such as additional output, switch-off and switch-on speeds can be
changed and read out via connection SA and SB. The Z-PA.SDL1 WLAN adapter can be used
for encoder access via web browser.
Also see about this
2 Z-PA.SDL.1 WLAN adapter: Programming device for HMG10P/PMG10P [} 33]
6.2.5
LED activity indicator
LED
INC1
INC2 (additional output incre-
mental
Status
Speed
Tab. 2: LED activity indicator
V1, T1 | HMG10 & HMG10P EtherNet/IP
TTL/RS422
≥ 2,5 V / ≤ 0,5 V
≤ 550 m bei 100 kHz
≤ 600 kHz
red
No function
Undervoltage
n
Overload
n
Excess temperature
n
Internal error
Speed higher than switching
speed (overspeed)
Operating Manual
Electrical installation
TTL/HTL (Vin = Vout)
≥ 2,5 V / ≤ 0,5 V (TTL)
n
≥ Ub − 3 V / ≤ 1,5 V (HTL)
n
≤ 550 m bei 100 kHz (TTL)
n
≤ 350 m bei 100 kHz (HTL)
n
≤ 600 kHz (TTL)
n
≤ 350 kHz (HTL)
n
green
No function
OK
OK
Speed below switching speed
|
6
I
29