Douglas Dynamics WESTERN ENFORCER 97540 설치 지침 매뉴얼 - 페이지 6
{카테고리_이름} Douglas Dynamics WESTERN ENFORCER 97540에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Douglas Dynamics WESTERN ENFORCER 97540 19 페이지. Ultramount 2 snowplow
페이지 인쇄LIFT FRAME TO T-FRAME ASSEMBLY
Pivot Plate Hole Position
IMPORTANT! Before assembling the lift frame to
the T‑frame, the pivot plate hole position must be
determined using the following procedure. If the truck
is not available, use hole 2. Adjustments can be made
later.
Before measuring the vehicle mount height, the
vehicle mount and receivers must be installed, ballast
must be installed, if required, and the vehicle must be
parked on a level surface.
Top Edge of
Receiver
d
1. Measure the distance "d" from the ground to the
top edge of the receiver bracket. Measure both
sides and determine average value for "d."
2. Use distance "d" from Step 1 and the following
chart to determine the proper pivot plate hole.
Pivot Plate Hole Chart
Distance "d"
15.25" – 16.5"
14.0" – 15.25"
12.75" – 14.5"
Hole 1
Hole 2
Hole 3
Lit. No. 74914, Rev. 01
INSTALLATION INSTRUCTIONS
Hole
1
2
3
Pivot Bar to Pivot Plates
1. Position the T‑frame between the pivot plates,
aligning the hole at each end of the pivot bar with
the proper pivot plate hole.
5/32" x 1-1/2"
Cotter Pin
3/4" Flat
Washer
2. On each side, insert a 3/4" x 2" clevis pin from the
inside of the lift frame through the correct pivot
plate holes. Secure the clevis pins with 3/4" flat
washers and 5/32" x 1‑1/2" cotter pins from the
parts bag.
6
3/4" x 2"
Clevis Pin
Pivot Plates
June 1, 2020